How to Replace an RV Dome for Ventadome®

Time to Complete:  10 minutes (depending on the level of expertise)

Tools Required:

1. Ventadome (V2092 or V2094)
2. #2 Phillips Screwdriver
3. Drill

These instructions apply to vents on utility, travel, motorhome, RV, and horse trailers.

Steps:

1. Use your drill to unscrew all the screws holding the garnish onto the ceiling.
2. Make sure that you save all the screws when you remove the garnish because you will reuse these screws.
3. Remove the screen by gently pulling it upwards.
4. Remove the screw on the operator’s handle with a #2 Phillips Screwdriver. Once the screw is removed, pull off the handle to remove it.
5. Slide off the inside trim piece.
6. Remove the two screws on the operator with your drill and slide the operator off the dome.
7. Safely go onto the roof of your trailer to remove the dome.
8. Replace the dome and line up the holes on the hinge. Then close the dome on the roof.
9. Back inside your trailer and reinstall your operator. Take the clip of the operator and slide it on the runner on the dome.
10. Using the two screws you removed from the operator, reinstall them using a drill.
11. Place the trim piece back on.
12. Pop the screen back into place